Haenlein-Software Forum

When I record I get several files if the recording is > 1 540 096 kB. The first one "NAME".trp, the second "NAME".001 and sofort. The programme just converts the .trp fil. I run Studio Pro as a try out.
Best regard Jabris

Load each of these files into the software.
If each is displayed within the left box, please bring the files into the right order.
Afterwards select all of them and press the button below showing three papers with a I, II and III on it.

This will append all files to one recording. (only use this with subfiles of a recording like you described)

Now a single file should be displayed and the size will show the full recording size.
Further you can navigate through the whole recording within the timeline.

Why is the recording split though? I remember that on FAT32 over 4GB was a problem but not on NTFS etc.

Well, you have the option to use a FAT32 hard drive. Therefore they use the splitting to avoid any limitations.
There is no real reason for choosing about 1,5 GB per file instead of close to 4 GB from my point of view.